FUP Messages
File Utility Program (FUP) Reference Manual—523323-014
3-17
Cause. An attempt was made to duplicate a partition PARTONLY. FUP detected that
the partition data would be reshuffled among the partitions.
Effect. The command fails.
Recovery. Reissue the command without the PARTONLY option, and convert the file
as a whole.
Cause. The OLD option of the DUP command was used.
Effect. This is only a warning that any alternate-key files must be reloaded.
Duplication of the primary file proceeds.
Recovery. After the duplication completes, you need to update the alternate-key files
using the LOADALTFILE command.
Cause. A SUSPEND command issued against filename found no RELOAD
operation for filename.
Effect. The command fails.
Recovery. Check that you spelled filename correctly or that filename exists
before retrying SUSPEND.
Cause. A Safeguard protected file was duplicated, but the new file is not Safeguard
protected.
Effect. The file is duplicated; this is only a warning.
Recovery. Use the Safeguard command interpreter to establish Safeguard protection
for the file.
Cause. No status information was found for a RELOAD operation, or the information
found was invalid or inconsistent.
Effect. The STATUS command fails.
Recovery. Check that you spelled filename correctly or that filename exists
before retrying STATUS.
NO CHANGE TO ALT KEY FILES
filename: NO RELOAD IN PROGRESS
filename: NO SAFEGUARD PROTECTION
filename: NO STATUS AVAILABLE
NO SUCH LINE
To Next Page
Loading...
Need help?
General