FUP Messages
File Utility Program (FUP) Reference Manual—523323-014
3-23
Recovery. If the error is not apparent, try using INFO on a file with a similar file set
without using a qualified file set.
Cause. Qualified file set is either not permitted in this command, or it was used in an
incorrect position.
Effect. The command fails.
Recovery. Use the qualified file set in the correct position, or retry the command
without a qualified file set (if they are not permitted in this command).
Cause. In the primary file, nnn records had partial alternate-key fields. The actual
record did not contain the full length of the alternate key. The corresponding alternate-
key records were not generated in the destination file by LOADALTFILE or
BUILDKEYRECORDS.
Effect. The LOADALTFILE or BUILDKEYRECORDS command finishes, but no
alternate-key records are generated for the records with partial alternate keys. This is
only a warning.
Recovery. Retry the command after padding the records in the primary file so that
alternate keys are always completely contained in the records.
Cause. A FUP command was entered that attempted to assign a record size
inappropriate for the file format of the file.
Effect. The command fails.
Recovery. Reenter the command with an appropriate record size. For a list of
appropriate record sizes, see Table 1-1, File Format Codes, on page 1-23.
Cause. A LOAD command was issued.
Effect. The operation completes, and nn indicates the number of records actually
loaded. If the EMPTYOK option was used to load an empty source file, nn is 0.
Recovery. Informational message only; no corrective action is needed.
QUALIFIED FILESETS NOT PERMITTED
nnn RECORDS CONTAIN INCOMPLETE ALTERNATE KEY FIELDS
(ALTERNATE KEY RECORDS NOT GENERATED)
RECORD SIZE EXCEEDS THE APPLICABLE LIMIT. FORMAT 2 DOES NOT
ALLOW AS BIG A RECORD AS FORMAT 1 FOR SAME BLOCK SIZE
RECORDS LOADED: nn
REELS PARAMETER NOT ALLOWED FOR LABELED TAPES
To Next Page
Loading...
Need help?
General