Set up and Installation
Install from the Server using a Browser Window
Set up Additional Computers
Install from the Software Installation Disc
1. Insert the Software Installation Disc into a computer connected to the network.
You must have administrative privileges to install. For additional information, see Installing the
Software on the First Computer.
2. Follow the instructions on the installation wizard.
The installation process is identical to installing on the first computer except for the following:
• The Windows Home Server Setup does not run.
• Your server password is required to install, as shown in the following figure:
Install the from the Server using Windows XP or Windows Vista
1. At the computer, click Start, and then Run.
Type the following (UNC) network address:
\\hpstorage\Software\Home Server Connector Software\setup.exe
The network address will be different if you renamed your server. In this case type,
\\<server name>\Software\Home Server Connector Software\setup.exe
2. Click OK.
Install from the Server using a Browser Window
1. Open a web browser and type the following address http://hpstorage:55000.
The address will be different if you renamed your server. In this case, type http://<server
name>:55000. The Windows Home Server Connector Setup window opens.
29
To Next Page
Loading...
Need help?
General