HP Z Series User Manual

Memory fan duct
To remove the memory fan duct, use these procedures.
Before removing the memory fan duct, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 18).
2. Remove the access panel (see Access panel on page 20).
Remove the memory fan duct:
1. Release the memory fan duct by lifting the tabs (1).
2. Remove the memory fan duct (2).
To install the memory fan duct, reverse the removal procedure.
Front card guide and fan
To remove the front card guide and fan, use these procedures.
Before removing the front card guide and fan, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 18).
2. Remove the access panel (see Access panel on page 20).
Remove the front card guide and fan:
1. If installed, disconnect the cables from the placeholder sockets (1) on the front card guide and fan
housing.
2. Release the two retention clips (2) that secure the front card guide and fan to the computer.
3. Tilt the front card guide and fan (3) away from the computer.
26
Chapter 4 Removal and replacement procedures

HP Z Series Specifications

General

Series	Z Series
Category	Desktop
Processor	Intel Xeon or Intel Core (depending on the specific model)
Operating System	Windows 10 Pro or Windows 11 Pro
Storage	SSD or HDD options, up to multiple TB
Graphics	NVIDIA Quadro or AMD Radeon Pro
Expansion Slots	Multiple PCIe slots
Ports	USB, DisplayPort, HDMI
Form Factor	Tower
Memory	Up to 256 GB DDR4 ECC or non-ECC SDRAM (depending on the specific model)
Power Supply	Various wattage options, typically 500W to 1000W (depending on the specific model)