Removal and replacement procedures 111
TPM module (optional)
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
To install the component:
1. Power down the server (on page 20).
2. Disconnect all peripheral cables from the server.
3. Remove the access panel (on page 21).
4. Remove the riser cage (on page 70).
5. Locate the TPM connector on the system board (see page 11 for connector locations).
6. Install the TPM module into the system.
To remove the component, reverse the installation procedure.
To Next Page
Loading...
