Operations 21
Remove the access panel
To remove the component:
1. Power down the server (on page 20).
2. Disconnect all peripheral cables from the server.
3. Remove the access panel:
a. Loosen the thumbscrew at the rear of the system securing the access panel to the chassis.
b. Remove the single screw at the front of the system securing the access panel to the chassis.
c. Using the grip areas on the access panel slide the access panel back about 1.5 cm (0.5 in) and
remove the access panel.
Turn the access panel over to locate the access panel label. This label provides information on installing
various options, flexible memory configurations, and LED status indicators.
To Next Page
Loading...
