Removal and replacement procedures 112
VROC upgrade module (optional)
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
1. Power down the server (on page 20).
2. Disconnect all peripheral cables from the server.
3. Remove the access panel (on page 21).
4. Remove the riser cage (on page 70).
5. Locate the VROC upgrade module connector on the system board (see page 11 for connector
locations).
6. Install the VROC upgrade module.
To remove the component, reverse the installation procedure.
To Next Page
Loading...
