HPE Cloudline CL2200 Gen10

System utilities 32
Navigating the BIOS setup menu screen
Use the keys listed on the bottom right of the Setup screen to work your way through the various BIOS
menu and submenu screens. The table below lists these keys and their respective functions.
Key
Function
Left / Right arrow keys
Move the cursor to the menu screen you want. The currently selected
screen will be highlighted and the items it contain will be shown.
Up / Down arrow keys
Move the cursor to the item you want. The currently selected field will be
highlighted.
Enter
• To open the page for the currently selected menu/submenu
• To apply a field value.
+ / - keys
To select a value for the currently selected field (only if it is
user-configurable). Press these keys repeatedly to display all possible
entries. A parameter that is enclosed in square brackets [ ] is
user-configurable. Black font parameters are not user-configurable for
one of the following reasons:
• The field value is auto-configured or auto-detected.·
• The field value is informational only.
• The field is password-protected.
F1
To bring up the General Help window. The General Help window
describes other setup navigation keys that are not displayed on the
legend bar.
F2
Restore the saved User Default settings.
F3
Load optimized default system values.
F10
Save and exit the BIOS setup screen.
Esc
If you press this key:
• On one of the primary menu screens, the Exit menu displays.
• On a submenu screen, the previous screen displays.
• When you are making selections from a pop-up menu, closes the
pop-up without making a selection.
Remote Flash BIOS
To remotely flash BIOS on CL2200 Gen10 Server, visit the Hewlett Packard Enterprise Support Center for
complete step-by-step instructions. The document can be found in the RemoteUpdate folder of the BIOS
firmware package.