108
c. Access the details page for VLAN 10 to perform the following tasks:
− Add GigabitEthernet 1/0/1 to the tagged port list.
− Create VLAN-interface 10.
− Assign the IP address 2.1.1.1/24 to VLAN-interface 10.
5. On the switch, configure DDNS:
a. From the navigation tree, select Network > IP > Dynamic DNS.
b. Create a DDNS policy:
− Configure the policy name as 3322.
− Select the service provider www.3322.org.
− Configure the username as abc.
− Configure the password as 123.
− Configure the switch to send DDNS update requests every 15 minutes.
− Select the associated interface VLAN-interface 10.
− Configure the FQDN as whatever.3322.org.
c. From the navigation tree, select Network > IP > DNS.
d. Configure the IP address of the DNS server as 1.1.1.1.
Verifying the configuration
1. Change the IP address of the VLAN-interface 10 on the switch to 2.1.1.2/24.
2. After a period, ping the domain name whatever.3322.org from the host to verify that the
domain name is resolved to the IP address 2.1.1.2.
Static IPv6 address configuration example
Network requirements
As shown in Figure 29, configure VLAN-interface 10 on the switch to generate an EUI-64 address
with the prefix 2001::/64.
Figure 29 Network diagram
Configuration procedure
1. Configure the VLAN and VLAN interface:
a. From the navigation tree, select Network > Links > VLAN.
b. Create VLAN 10.
c. Access the details page for VLAN 10 to perform the following tasks:
− Add GigabitEthernet 1/0/1 to the tagged port list.
− Create VLAN-interface 10.
Host
Host Host
Vlan-int10
GE1/0/1
Switch
To Next Page
Loading...
