147
Syntax
poe update { full | refresh } filename [ pse pse-id ]
Views
User view
Predefined user roles
network-admin
Parameters
full: Upgrades the PSE firmware in full mode.
refresh: Upgrades the PSE firmware in refresh mode.
filename: Specifies the name of the upgrade file, a case-sensitive string of 1 to 64 characters. The
specified file must be in the root directory of the file system of the device.
pse pse-id: Specifies a PSE by its ID.
Usage guidelines
You can upgrade the PSE firmware in service in either of the following modes:
• Refresh mode—Updates the PSE firmware without deleting it. You can use the refresh mode
in most cases.
• Full mode—Deletes the current PSE firmware and reloads a new one. Use the full mode if the
PSE firmware is damaged and you cannot execute any PoE commands.
Examples
# Upgrade the firmware of PSE 7 in service.
<Sysname> poe update refresh POE-168.bin pse 7
quit
Use quit to log out of the system.
Syntax
quit
Views
Any view
Predefined user roles
network-admin
network-operator
Usage guidelines
Executing this command in user view disconnects you from the device.
Examples
# Log out of the system.
<Sysname> quit
reboot
Use reboot to reboot stack member devices.
To Next Page
Loading...
