HPE OfficeConnect 1950 Series

140
Command Description
upgrade
{ tftp-server |
ipv6
ipv6-tftp-server }
bootrom
bootrom-filename
upgrade
{ tftp-server |
ipv6
ipv6-tftp-server }
runtime boot
boot-package
system
system-package [
feature
feature-package&<1-30>]
upgrade
{ tftp-server |
ipv6
ipv6-tftp-server }
runtime file
ipe-filename
Downloads the specified file from a TFTP server and
specify the file as the file to be used at the next startup. If
the device is a stack member device, the setting of this
command applies to all member devices in the stack.
xtd-cli-mode
undo xtd-cli-mode
Switches to extended CLI mode. Extended CLI is for the
use of Hewlett Packard Enterprise support personnel
when troubleshooting an issue. This is not a supported
feature for operation in customer networks.
Restores the default.
display poe pse
Use display poe pse to display PSE information.
Syntax
display poe pse [ pse-id ]
Views
User view
Predefined user roles
network-admin
network-operator
Parameters
pse-id: Specifies a PSE by its ID.
Usage guidelines
If you do not specify a PSE, this command displays information about all PSEs.
Examples
# Display detailed information about PSE 7.
<Sysname> display poe pse 7
PSE ID : 7
Slot No. : 1
SSlot No. : 0
PSE Model : LSP7POEB
PSE Status : Enabled
Power Priority : Low
Current Power : 0.0 W
Average Power : 0.0 W
Peak Power : 0.0 W
Max Power : 370.0 W
Remaining Guaranteed Power : 370.0 W
PSE CPLD Version : -
PSE Software Version : 130