13
Menus Tasks
Interfaces
• Display interfaces and their attributes, including:
{ Interface status.
{ IP address.
{ Speed and duplex mode.
{ Interface description.
• Change interface settings.
• Delete logical interfaces.
Link Aggregation Create, modify, or delete Layer 2 aggregation groups.
Storm Constrain
• Set the statistics polling interval.
• Set storm control parameters.
• Display storm control information.
Isolation
• Create isolation groups.
• Modify isolation groups.
Links
VLAN
• Configure port-based VLANs.
• Create VLAN-interfaces.
Voice VLAN
• Assign ports to voice VLANs.
• Set the port mode to manual or automatic.
• Set the voice VLAN mode to normal or security.
• Configure the QoS settings for voice packets.
• Add OUI addresses.
MAC
• Create or delete static MAC entries, dynamic MAC entries, and
blackhole MAC entries.
• Display existing MAC entries.
STP
• Enable or disable STP globally.
• Enable or disable STP on interfaces.
• Configure the STP operating mode as STP, RSTP, PVST, or MSTP.
• Configure instance priorities.
• Configure MST regions.
LLDP
• Enable or disable LLDP.
• Modify the LLDP operating mode.
• Modify the interface mode.
• Configure LLDP to advertise the specified TLVs.
DHCP Snooping
• Configure a port as a trusted or untrusted port.
• Record and back up DHCP snooping entries.
• Configure the following features for DHCP snooping ports:
{ MAC address check.
{ DHCP-REQUEST check.
{ DHCP packet rate limit.
{ Max DHCP snooping entries.
• Enable support for Option 82. If Option 82 is enabled, you can configure
the handling strategy, the padding format, and the padding contents for
Option 82.
IP
IP
• Configure the method to obtain an IP address (DHCP or static).
• Configure the IP address or MTU of an interface.
• Create a loopback interface.
To Next Page
Loading...
