a. Power down the server.
b. Disconnect all peripheral cables from the server.
c. Disconnect each power cord from the server.
2. Disengage the server from the rack:
a. Pull down the quick release levers on each side of the server.
b. If necessary, use a T-25 Torx screwdriver to loosen the shipping screws.
c. Slide the server out of the rack.
Removing the server from the rack
WARNING:
This server is heavy. To reduce the risk of personal injury or damage to the equipment:
• Observe local occupational health and safety requirements and guidelines for manual material handling.
• Get help to lift and stabilize the product during installation or removal, especially when the product is not
fastened to the rails. Hewlett Packard Enterprise recommends that a minimum of two people are required for all
rack server installations. A third person may be required to help align the server when the server is installed
higher than chest level.
• Use caution when installing the server in or removing the server from the rack; it is unstable when not fastened
to the rails.
To remove the server from a Hewlett Packard Enterprise, Compaq-branded, Telco, or a third-party rack:
Procedure
1. Power down the server.
2. Remove all power.
Operations
29
To Next Page
Loading...
