• Secondary riser cage
Removing the air bale
CAUTION: For proper cooling, do not operate the server without the access panel,
bales, expansion slot blanks, or
blanks installed. If the server supports hot-plug components, minimize the amount of time the access panel is open.
Procedure
1.
If installed,
remove the front bezel.
2.
Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Do one of the following:
•
Extend the server from the rack.
• Remove the server from the rack.
Operations
37
To Next Page
Loading...
