4.12.2 Energy pack specifications
4.12.3 Installing an energy pack
4.13 Expansion card options
4.13.1 PCIe expansion option population rules
4.13.2 Installing an expansion card
4.14 M.2 SSD options
4.14.1 Installing the HPE NS204i-p NVMe OS Boot Device option
4.14.2 Installing the M.2 SATA SSD enablement option
4.14.3 Installing the M.2 SSD pass-through card option
4.15 Chassis intrusion detection switch option
4.15.1 Installing the chassis intrusion detection switch
4.16 Serial port option
4.16.1 Installing the serial port option
4.17 Internal USB device option
4.17.1 Installing an internal USB device
5 Cabling
5.1 Cabling guidelines
5.2 Internal cabling management
5.3 Storage cabling
5.3.1 2 LFF non-hot-plug drive cabling
5.3.2 2 LFF hot-plug drive cabling
5.3.3 4 SFF hot-plug drive cabling
5.3.4 4 + 2 SFF hot-plug drive cabling
5.3.5 4 + 2 SFF hot-plug drive with tri-mode controller cabling
5.3.6 Energy pack cabling
5.3.7 Storage controller backup power cabling
5.4 Optical drive cabling
5.5 M.2 SATA SSD add-in card cabling
5.6 M.2 SSD pass-through card cabling
5.7 Fan cabling
5.8 Chassis intrusion detection switch cabling
5.9 Serial port cabling
5.10 Power supply cabling
6 Configuration and diagnostic utilities
7 Troubleshooting
7.1 NMI functionality
7.2 Troubleshooting resources
8 System battery replacement
8.1 System battery information
8.2 Removing and replacing the system battery
9 Safety, warranty, and regulatory information
9.1 Regulatory information
9.1.1 Notices for Eurasian Economic Union
9.1.2 Turkey RoHS material content declaration
To Next Page
Loading...
