10. Install the access panel .
11. Install the server into the rack.
12. Connect all peripheral cables to the server.
13. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
14. Power up the server.
ResultsResults
The installation is complete.
Installing an expansion card in the primary riser cageInstalling an expansion card in the primary riser cage
PrerequisitesPrerequisites
Determine the fan requirement for the expansion option that you are installing.
When installing a full-length expansion card, the card retainer option is required .
Before you perform this procedure, make sure that you have the following items available:
T-10 Torx screwdriver
Phillips No. 1 screwdriver
About this taskAbout this task
CAUTION:CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCIe slots have either a
riser slot blank or an expansion card installed.
To Next Page
Loading...
