SubtopicsSubtopics
Installing a redundant hot-plug power supplyInstalling a redundant hot-plug power supply
Installing a redundant hot-plug power supplyInstalling a redundant hot-plug power supply
PrerequisitesPrerequisites
Before installing this option, be sure you have the following:
The components included with the hardware option kit
ProcedureProcedure
1. Observe the following alerts:
CAUTION:CAUTION: All power supplies installed in the server must have the same output power capacity. Verify that all
power supplies have the same part number and label color. The system becomes unstable and may shut down when
it detects mismatched power supplies.
CAUTION:CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are
populated with either a component or a blank.
2. Access the product rear panel .
3. Remove the blank.
WARNING:WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply or power supply blank to
cool before touching it.
4. Insert the power supply into the power supply bay until it clicks into place.
To Next Page
Loading...
