10. If the card requires rear support, install the GPU support bracket.
11. Install the primary PCI riser cage .
12. Install the access panel .
13. Install the server in the rack.
14. Connect each power cord to the server.
15. Connect each power cord to the power source.
16. Power up the server .
Secondary PCI riser optionsSecondary PCI riser options
The primary PCI riser cage supports the following options:
x16 full-height riser kit
x16 low-profile riser kit
SubtopicsSubtopics
Installing a secondary low-profile riser optionInstalling a secondary low-profile riser option
Installing a secondary full-height riser optionInstalling a secondary full-height riser option
Installing an expansion board in the secondary riser cageInstalling an expansion board in the secondary riser cage
Installing a secondary low-profile riser optionInstalling a secondary low-profile riser option
PrerequisitesPrerequisites
This option requires a dual processor configuration.
Before installing this option, be sure that you have the components included with the hardware option kit.
About this taskAbout this task
When installed, this riser cage provides an additional low profile slot and supports half-length/half-height expansion boards.
ProcedureProcedure
1. Observe the following alerts:
WARNING:WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION:CAUTION: To prevent damage to electrical components, properly ground the server before beginning any
To Next Page
Loading...
