Removing and replacing the Removing and replacing the enclosureenclosure rails rails
PrerequisitesPrerequisites
If you are replacing the enclosure mounting rails from a threaded-hole enclosure, make sure that you have a T-25 Torx screwdriver
available.
About this taskAbout this task
The illustrations used in this procedure show an icon on the upper right corner of the image. This icon indicates whether the action shown in
the image is for a round-hole, square-hole, or a threaded-hole enclosure.
Round-hole enclosure Square-hole enclosure Threaded-hole enclosure
ProcedureProcedure
1. Power down the server.
2. If installed, open the cable management arm.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the enclosure.
6. Place the server on a flat, level surface.
7. To remove the sliding rails, do the following:
To Next Page
Loading...
