CAUTION:CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Back up all server data.
2. If installed, remove the front bezel .
3. Observer the drive LED status and determine if the drive can be removed.
4. Remove the drive.
ResultsResults
To replace the component, reverse the removal procedure.
Removing a hot-plug NVMe driveRemoving a hot-plug NVMe drive
About this taskAbout this task
CAUTION:CAUTION: For proper cooling, do not operate the server without the access panel, baffles, expansion slot covers, or blanks
installed. If the server supports hot-plug components, minimize the amount of time the access panel is open.
ProcedureProcedure
1. Determine the status of the drive from the hot-plug drive LED definitions.
2. Back up all server data on the drive.
3. Remove the drive.
To Next Page
Loading...
