14. Remove the protective cover from the new heatsink.
15. Install the heatsink.
Removing and replacing the system boardRemoving and replacing the system board
About this taskAbout this task
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack.
b. Remove the server from the rack.
4. Remove all power supplies.
5. Remove the access panel.
6. Take note of port numbers and cables connections to risers and the system board.
7. Disconnect and remove all cables that are connected to risers or the system board.
8. Remove all riser cages.
9. Remove the controller.
10. Remove all fans.
11. Remove all fan blanks.
To Next Page
Loading...
