ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing a primary riser cardRemoving and replacing a primary riser card
About this taskAbout this task
Secondary risers are spared with the riser cage.
CAUTION:CAUTION: To prevent damage to the server or expansion boards, power down the server and remove all AC power cords
before removing or installing the PCI riser cage.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove the access panel.
5. Remove the riser cage.
To Next Page
Loading...
