HPE ProLiant DL365 Gen11 - Removing and replacing an M.2 SSD; About this task; Procedure

Removing and replacing an M.2 SSDRemoving and replacing an M.2 SSD
About this taskAbout this task
This procedure is for drives on the system board, riser, or expansion card. Do not use this procedure on uFF drives.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove the access panel.
5. Remove the primary riser cage.
6. Remove the M.2 SSD.
HPE ProLiant DL365 Gen11 Server Maintenance and Service Guide 44