a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove the access panel.
5. Disconnect the cable and then remove the battery or capacitor pack.
When removing the cable, remove the cable and cable extender.
ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing a heatsinkRemoving and replacing a heatsink
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
The components included with the hardware option kit
T-20 Torx screwdriver
Two 1.0 gm (0.5 ml) or four 0.5 gm (0.25 ml) of thermal grease
Alcohol wipe
About this taskAbout this task
This procedure shows a high-performance heatsink as an example. The installation process is the same for both the standard and high-
performance heatsinks.
Before performing this procedure, Hewlett Packard Enterprise recommends identifying the processor and socket components .
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack .
To Next Page
Loading...
