ResultsResults
To replace the component, reverse the removal procedure.
Removing and replacing a PCIe blankRemoving and replacing a PCIe blank
About this taskAbout this task
CAUTION:CAUTION: To prevent damage to the server or expansion boards, power down the server and remove all AC power cords
before removing or installing the PCI riser cage.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove the access panel.
5. Remove the riser cage.
6. Remove the riser blank.
To remove blanks from the primary riser:
To Next Page
Loading...
