CAUTION: When routing cables, always be sure that the cables are not in a position where they
can be pinched or crimped.
10. Connect the SID module cable to the front power/USB 3.0 connector.
11. Install the fan cage.
12. Install the air baffle.
13. Install the access panel.
14. Slide the server into the rack.
15. Connect each power cord to the server.
16. Connect each power cord to the power source.
17. Power up the server.
The installation is complete.
Installing a FlexibleLOM adapter
Prerequisites
• The components included with the hardware option kit
• A T-10 Torx screwdriver might be needed to unlock the access panel.
Procedure
1. Power down the server .
2. Do one of the following:
Hardware options installation 135
To Next Page
Loading...
