Installing a front 2SFF NVMe/SAS/SATA Premium drive cage
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• T-10 Torx screwdriver
• The components included with the hardware option kit
• This installation requires a universal media bay.
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
•
Extend the server from the rack.
• Remove the server from the rack .
4. Remove the access panel.
5. Remove the front bay blank.
6. Remove the optical disk drive tray from the universal media bay.
Hardware options installation 99
To Next Page
Loading...
