Installing an NVMe drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all drive
and device bays are populated with either a component or a blank.
Procedure
1. Remove the drive blank.
2. Prepare the drive.
3. Install the drive.
4. Observe the LED status of the drive.
Installing a uFF drive and SCM drive carrier
IMPORTANT: Not all drive bays support the drive carrier. To find supported bays, see the server
QuickSpecs.
Procedure
1. If needed, install the uFF drive into the drive carrier.
74 Hardware options installation
To Next Page
Loading...
