a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
4. Remove the access panel.
5. Do one of the following:
• Remove the air baffle.
• If installed, remove the 4LFF midplane drive cage.
6. Do one of the following:
• For Type-a Smart Array controllers, install the controller into the Smart Array connector.
• For Type-p Smart Array controllers, install the controller into an expansion slot.
7. Cable the controller.
The installation is complete.
Installing an HPE Smart Array P824i-p MR Gen10 controller in a configured
server
Procedure
1. Back up data on the system.
2. Close all applications.
3. Update the server firmware if it is not the latest revision.
86 Hardware options installation
To Next Page
Loading...
