Removal and replacement procedures 63
CAUTION: To prevent damage to electrical components, properly ground the server before
beginning any installation procedure. Improper grounding can cause ESD.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
To remove the component:
1. Power down the server (on page 24).
2. Release the power cord from the strain relief clip.
3. Remove the strain relief clip from RPS and retain the clip for future clip.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Place the server on a sturdy, level surface.
6. Remove the access panel (on page 24).
To Next Page
Loading...
