Hardware options installation 124
Power supply options
Hot-plug power supply module
CAUTION: All power supplies installed in the server must have the same output power
capacity. Verify that
all power supplies have the same part number and label color. The system
becomes unstable and may shut down when it detects mismatched power supplies.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
To install the component:
1. Access the product rear panel.
2. Remove the blank.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the power supply or
power supply blank to cool before touching it.
3. Insert the power supply into the power supply bay until it clicks into place.
4. Connect the power cord to the power supply.
To Next Page
Loading...
