Hardware options installation 76
10.
Route and connect the cable.
11. Install the fan cage (on page 38).
12. Install the air baffle (on page 35).
13. Install the access panel (on page 33).
14. Do one of the following:
o If the server is in a tower configuration, return the server to an upright position.
o If the server is in a rack configuration, slide the server into the rack.
15. Connect each power cord to the server.
16. Connect each power cord to the power source.
17. Power up the server ("Powering up the server" on page 30).
18. Do one of the following:
o For tower models, install the tower bezel (on page 31).
o For rack models, install the security bezel ("Security bezel option" on page 50).
Installing a SAS Expander option
The SAS Expander requires an Smart Array or HBA. A SAS Expander cannot be connected to H240ar or
P440ar Flexible Smart Array controller cards. The SAS Expander kit includes two cables to connect from
the Smart Array or Host Bus Adapter PCIe expander card to the SAS Expander.
Expanders can only be installed in SFF models.
Check that you have installed the latest firmware for the controllers, HBAs, and the expander card. To
download the latest firmware, see the Hewlett Packard Enterprise website
(http://www.hpe.com/support/hpesc).
To install the component:
1. Back up all server data.
2. Do one of the following:
o For tower models, open and remove the tower bezel ("Remove the tower bezel" on page 31).
o For rack models, if installed, remove the security bezel ("Remove the security bezel (optional)"
on page 31).
3. Power down the server (on page 30).
To Next Page
Loading...
