Hardware options installation 77
4.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
o For tower models, place the server on a flat, level surface with the access panel facing up.
o For rack models, extend the server from the rack (on page 34).
6. Remove the access panel (on page 32).
7. Remove the air baffle (on page 34).
8. Remove the fan cage (on page 37).
9. Remove the expansion slot retainer cover and the slot blank.
10. Identify the ports on the expander card.
11. Connect the Expander card to the storage controller. Do one of the following:
To Next Page
Loading...
