HPE ProLiant ML350 Gen9 - Install the Fan Cage

Operations 38
o
For rack models, extend the server from the rack (on page 34).
5. Remove the access panel (on page 32).
6. Remove the air baffle (on page 34).
7. Remove the fan cage.
Install the fan cage
1. Install the fan cage.
2. Install the access panel (on page 33).
3. Do one of the following:
o If the server is in a tower configuration, return the server to an upright position.
o If the server is in a rack configuration, slide the server into the rack.
4. Connect each power cord to the server.
5. Connect each power cord to the power source.
6. Power up the server ("Powering up the server" on page 30).