About this taskAbout this task
In this page, the user can choose to perform manual partition, or let the operating system perform the automatic partition during
installation.
For automatic partition:For automatic partition:
1. Leave the Use Recommended Partition check box checked.
2. Open Select one following drive to configure as OS drive drop-down menu, select the hard drive on which you wish you install the OS.
For manual partition:For manual partition:
1. Uncheck Use Recommended Partition check box; then the below section displays the chart for the default partition. The chart varies
based on the Operating system and version.
For Windows/Hyper-V:
Mount Point Size (MB) File System Type Partition Label
Recovery 500 NTFS
EFI system partition 100 FAT32
Microsoft reserved partition 16 NTFS
Basic data partition Rest of HDD NTFS
While users can only make change on the Basic data partition, the rest of the partitions are also crucial for maintenance, and should not
be changed.
For SUSE system:
Mount Point Size (MiB) File System Type Partition Label
Swap 2000 swap
/boot/efi 150 vfat
/ 40000 btrfs
/home Rest of HDD Xfs
While the user can only make change on /home partition, the rest of the partitions are crucial for maintenance and should not be
changed.
For Red Hat Enterprise Linux system:
To Next Page
Loading...
