Dedicated spareDedicated spare
The dedicated spare drive activates any time a drive within the array fails.
Failure spare activationFailure spare activation
Failure spare activation mode activates a spare drive when a member drive within an array fails using fault tolerance methods to regenerate
the data.
Assigning one or more online spare drives to an array enables you to postpone replacement of faulty drives.
Performing maintenancePerforming maintenance
NOTE:NOTE:
The following maintenance tasks are not supported on an HPE Synergy compute module:
Downloading Active Health System data
Updating firmware
Using iLO Configuration Utility
To perform these tasks on an HPE Synergy compute module, you must use HPE OneView.
SubtopicsSubtopics
Updating firmwareUpdating firmware
Setting Intelligent Provisioning PreferencesSetting Intelligent Provisioning Preferences
Downloading Active Health System dataDownloading Active Health System data
Using Deployment SettingsUsing Deployment Settings
Using the BIOS Configuration (RBSU) utilityUsing the BIOS Configuration (RBSU) utility
About iLO ConfigurationAbout iLO Configuration
Configuring Intelligent StorageConfiguring Intelligent Storage
About Hardware Validation ToolAbout Hardware Validation Tool
One-button secure eraseOne-button secure erase
Using System Erase and ResetUsing System Erase and Reset
Creating a RAID configuration with SSACreating a RAID configuration with SSA
Updating firmwareUpdating firmware
PrerequisitesPrerequisites
1. To update firmware, make sure that port 443 is open for SSL communication.
2. Generate token by the following steps:
To Next Page
Loading...
