EasyManua.ls Logo

HPE ProLiant

HPE ProLiant
59 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SymptomSymptom
When installing Red Hat Enterprise Linux or VMware from the Rapid Setup with install method "Assisted Install" after the file copy process
is finished, system directly boot into Image without any configuration instead of start the installation process.
CauseCause
Red Hat Enterprise Linux and VMware are not supported install with secure boot enabled.
ActionAction
1. Disable secure boot in the BIOS.
2. Install target OS from the Intelligent Provisioning.
3. Enable secure boot in the BIOS.
Troubleshooting VMware-specific issuesTroubleshooting VMware-specific issues
SubtopicsSubtopics
Server reboots during VMware Assisted installationServer reboots during VMware Assisted installation
Server reboots during VMware Assisted installationServer reboots during VMware Assisted installation
SymptomSymptom
When performing a VMware Assisted installation with DVD as source media, after Pre-installation is complete, the server reboots and the
server begins loading the ESXi installer again rather than opening the OS.
CauseCause
VMware OS installed on HDD continuously reboots if a USB is connected to SUT.
ActionAction
1. Remove the USB device.
2. Continue the installation.
WebsitesWebsites
Intelligent Provisioning 4.20 User Guide for HPE ProLiant and Synergy Gen11 Servers 56

Table of Contents

Related product manuals