Using Deployment Settings package to configure a single serverUsing Deployment Settings package to configure a single server
About this taskAbout this task
IMPORTANT:IMPORTANT: Do not interrupt the configuration process.
ProcedureProcedure
Do one of the following:
1. To use the deployment you created on the same server, click DeployDeploy.
2. To use a previously created deployment that not exist on this server:
Select Deployment Settings > Import.
From Network Share enter:
Server Name or IP Address —Server name or IP address of the server that hosts the OS contents. If a server name is specified, a
DNS entry is also required.
Share Name—The name of the network share using Server Message Block (SMB) protocol that hosts the OS contents.
Domain Name—Name of the domain that hosts the network share.
Network Share User —User name used to access the network share.
Network Share Password (not encrypted) and Confirm Password —Password for the user name used to access the network
share.
From USB Drive
a. Insert the USB key containing the deployment.
b. Select the deployment from USB and click Next.
c. Click Deploy.
NOTE:NOTE: The newly imported deployment is added with the prefix "New Import".
Deployment Settings actionsDeployment Settings actions
IconIcon DescriptionDescription
Click the Deploy icon to launch the automatic configuration utility.
Click the Edit icon to change the following options:
Version Information
Operating System parameters
Intelligent Provisioning Preferences
Array Configuration information
ROM Settings
Hardware Validation Tool
Click the Delete icon to delete the selected deployment.
Click Download to download the performance package to a network share or a USB drive.
To Next Page
Loading...
