Figure 6: HPE Synergy Composer (1st gen) and an HPE Synergy Image Streamer (left) and HPE Synergy Composer2
(right)
Item Description Function
1 UID LED • Solid blue — Illuminates to locate the appliance module.
• Flashing blue — Indicates appliance module firmware update. Do not
power o or remove appliance module when the UID LED is flashing.
2 Health LED Indicates the health of the appliance module.
• Solid green — Normal operation
• Flashing amber — Warning
• Flashing red — Critical error
The Health LED provides health status of the appliance module. If the
Health LED indicates a warning or a critical error, connect to the HPE
Synergy Console to troubleshoot.
3 Activity LED Indicates which appliance module is active.
• O — Indicates that the appliance module is the standby in a Highly
Available configuration or HPE OneView is in an error state.
• Solid green — Indicates that the appliance module is active.
• Flashing green — Indicates that the reset button has been pressed
and held for greater than 10 seconds, which initiates a reimaging of
the appliance module. The active LED does not continue to flash
green during the reimaging process.
Table Continued
Component and LED identification 19
To Next Page
Loading...
