More information
Powering down the graphics expansion module
Removing the graphics expansion module from the frame
Removing and replacing the Multi-MXM graphics expansion
Procedure
1. Power down the graphics expansion module.
2. Remove the graphics expansion module from the frame.
3. Place the graphics expansion module on a flat, level surface.
4. Remove the access panel.
5. Remove the side screws.
6.
If applicable, remove mezzanine cards 4 and 5.
7.
Unscrew the four mezzanine assembly screws, and then remove the assembly.
Removal and replacement procedures
44
To Next Page
Loading...
