HPE Synergy 480 Gen10

Removing and replacing DIMMs
Procedure
1. Power down the graphics expansion module.
2. Remove the graphics expansion module.
3. Place the graphics expansion module on a flat, level work surface.
4. Remove the access panel.
5. If applicable, remove the graphics expansion from the compute module.
6. Remove the DIMM
bales.
NOTE: When accessing the right DIMM
bale, leave the energy pack option installed, and place the DIMM bale upright on
top of the heatsink.
7. Remove the DIMM.
To determine DIMM slot locations, see DIMM slot locations.
To replace the component, reverse the removal procedure. Use HPE UEFI System Utilities to configure the memory mode.
CAUTION:
• To prevent improper cooling and thermal damage, always install DIMMs of the same height in the graphics
expansion module.
• This graphics expansion module does not support mixing standard and nonstandard height DIMMs.
More information
Powering down the graphics expansion module
Removing the graphics expansion module from the frame
Removing the access panel
Removing and replacing the Multi-MXM graphics expansion
Removing the PCIe graphics expansion from the compute module
Removal and replacement procedures
59