HPE Synergy 480 Gen10

To replace the component, reverse the removal procedure.
NOTE: To use mezzanine slot 2, the heatsink must have an airflow
bale. To install a Type C mezzanine option card into
mezzanine slot 2, remove the airflow bale. If a Type C mezzanine option card is not in mezzanine slot 2, leave the airflow
bale installed.
More information
Powering down the graphics expansion module
Removing the graphics expansion module from the frame
Removing the access panel
Removing and replacing the graphics mezzanine adapter board
Procedure
1.
Power down the graphics expansion module.
2.
Remove the graphics expansion module.
3.
Place the graphics expansion module on a flat, level work surface.
4.
Remove the access panel.
5.
Remove the graphics mezzanine assembly.
6. Remove two screws.
Removal and replacement procedures
82