HPE Synergy 480 Gen10

CAUTION: To avoid damaging the connector housing component, be sure to orient the drive backplane connectors
so that they are facing the drive slots.
To replace the component, reverse the removal procedure.
More information
Powering down the graphics expansion module
Removing the graphics expansion module from the frame
Removing the access panel
Removing and replacing the Multi-MXM graphics expansion
Removing the PCIe graphics expansion from the compute module
Removing and replacing the internal SATA board
Procedure
1.
Power down the graphics expansion module.
2.
Remove the graphics expansion module.
3.
Place the graphics expansion module on a flat, level work surface.
4. Remove the access panel.
5. If applicable, remove the graphics expansion from the compute module.
6.
Remove all drives.
7. Remove all drive blanks.
8.
Remove the front panel/drive cage assembly.
9. Remove the Internal SATA board.
Removal and replacement procedures
55