HPE Synergy 480 Gen10

Replacing the graphics mezzanine heatsink
Procedure
1. Squeeze one half (0125 ml) of the contents of the 025 ml syringe on top of the graphics card in the pattern indicated in
the following image. The GPU on your graphics card may look dierent.
NOTE:
• Heatsink spare parts include pre-applied thermal grease. For graphics card spare parts, order the thermal grease kit as
well. For more information, see mechanical component listing.
• Do not remove the white thermal putty from the bottom of the heatsink. The thermal putty locations are shown in the
following image. The thermal putty on your graphics card may look dierent.
2.
Install the heatsink to the graphics card.
3.
Install the graphics mezzanine adapter board.
4.
Install the graphics mezzanine assembly.
Removing the Multi-MXM mezzanine pass-thru board
Procedure
1. Power down the graphics expansion module.
2. Remove the graphics expansion module from the frame.
3. Place the graphics expansion module on a flat, level work surface.
4. Remove the access panel.
5. Remove the Multi-MXM graphics expansion from the compute module.
6. Locate the mezzanine slots inside the compute module.
7. Loosen the screws on the mezzanine pass-thru board in mezzanine slot 1 of the compute module, and then remove the
board.
Removal and replacement procedures
85