HPE Synergy 480 Gen10

4. Remove the access panel.
5. Remove the graphics mezzanine assembly.
6. Remove the graphics mezzanine adapter board.
7. Remove the heatsink from the graphics card by loosening the four screws and carefully separating the heatsink from the
graphics card with a twist and lift motion. To ensure the correct orientation when reinstalling the heatsink, make note of
the orientation of the heatsink on the card.
NOTE: Your heatsink, graphics card, and backing plate may dier.
8.
Clean o any thermal grease remaining on the GPU (on the graphics card) using an alcohol wipe or a clean dry wipe. If
using alcohol, allow the alcohol to evaporate before continuing.
IMPORTANT: Do not remove the white thermal putty from the bottom of the heatsink. The thermal putty locations
are shown in the following image. The thermal putty on your graphics card may look
dierent.
More information
Powering down the graphics expansion module
Removing the graphics expansion module from the frame
Removing the access panel
Removal and replacement procedures
84