HPE Synergy 480 Gen10

To replace the component, reverse the removal procedure.
More information
Powering down the graphics expansion module
Removing the graphics expansion module from the frame
Removing the access panel
Removing or replacing a PCIe card or filler
Procedure
1.
Power down the graphics expansion module.
2.
Remove the graphics expansion module from the frame.
3.
Place the graphics expansion module on a flat, level surface.
4.
Remove the access panel.
5.
Remove PCIe card cages.
NOTE: To remove the front PCIe card cage, remove the front panel.
6.
Remove the PCA retainer.
7. Remove the PCA retainer screws.
8. Remove the PCIe card or blank from the card cage.
NOTE: Your configuration may have one double-wide card or two single-wide cards in the riser cage. If you have two
single-wide cards, use steps 6-8 to remove the second single-wide card.
Removal and replacement procedures 91