EASYTEST-COMBI519
EN - 11
5. GENERAL MENU
Pressing the MENU/ESC key in any condition of the instrument allows going back to the
general menu in which internal parameters may be set and the desired measuring function
may be selected.
MENU 15/10 – 18:04
AUTO :
Ra
,
RCD, M
DMM : Voltage/Freq.
RPE : Continuity
Lo
: 10A RPE.Test
M
: Insulation
RCD : Auto, Ramp, Man
LOOP : ZE/ZS Impedance
MENU 15/10 – 18:04
LoZ : High Res. Loop
1,2,3 : Phase Sequence
V%
: Voltage drop
SET : Settings
MEM : Data saved
PC : Data transfer
Upon selecting one of the listed measurements with the cursor and confirming with
ENTER, the instrument shows the desired measurement on the display.
5.1. SET – INSTRUMENT SETTINGS
Move the cursor to SET by means of the arrow keys (,)
and confirm with ENTER. Subsequently, the displays shows
the screen which allows accessing the various instrument
settings.
The settings will remain valid also after switching off the
instrument.
SET
15/10 – 18:04
Language
Country
Electrical system
General settings
Date and time
Information
5.1.1. Language
Move the cursor to Language by means of the arrow keys
(,) and confirm with ENTER. Subsequently, the display
shows the screen which allows setting the instrument
language.
Select the desired option by means of the arrow keys (,).
To store settings, press the ENTER key, to quit without
confirming the changes made, press the ESC key.
SET
15/10 – 18:04
English
Italiano
Español
Deutsch
Français
Portugues
To Next Page
Loading...
Need help?
General
