PVCHECKs-PRO
EN - 14
4. On the remote unit SOLAR03, activate “Pairing” (refer to
user manual of remote unit SOLAR03), so that it can be
recognized by the instrument. Once done, the serial
number of the remote unit and the message “Remote unit
detected. Pair? (ENTER/ESC)“ appear on the display as
shown in the screen to the side.
UREM 15/10 – 18:04
SOLAR03
ct
Stat.
Rec
SOLAR03 SN: 23051203
Remote Unit detected
Pair? (ENTER/ESC)
5. Confirm with ENTER on the instrument and on the
remote unit SOLAR03 for pairing. From now on, the
instrument and the remote unit are paired and it will not be
necessary to repeat these operations. To connect the
instrument to the remote unit, it will be sufficient to switch
them on, bring them near to each other and wait for
pairing.
UREM 15/10 – 18:04
SOLAR03
ct
Stat.
Rec
23051203
√
U.Rem. Connected
Find Unpai
Info Start
6. To start recording on an active and connected remote unit,
use the arrow keys or and select “Start””. The symbol
“ ” will subsequently appear.
UREM 15/10 – 18:04
SOLAR03
ct
Stat.
Rec
23051203
√
U.Rem. Connected
Find UnPai
Info Start
In case the instrument has previously been associated to two or more remote units, in
order to switch from a remote unit to another:
7. Use the arrow keys or and select “UnPair” and
confirm with ENTER to unpair the current remote unit. To
carry out this operation, it is not necessary that the
currently associated remote unit is also connected to the
instrument.
8. Use the arrow keys (,) to select the new remote unit.
The new unit must be switched on and be located within
the connection range of the instrument.
9. Use the arrow keys or and select “Pair” and confirm
with ENTER to connect the remote unit to the instrument.
10. The previously unpaired unit can also be deleted from the
list using “Del”.
UREM 15/10 – 18:04
SOLAR03
ct
Stat.
Rec
23051203
√
23061215
U.Rem. Connected
Find Unpai
Info Start
To Next Page
Loading...
Need help?
General
