● Slowly push or move battery packs to prevent damage and collision.
● To prevent battery packs from falling o, start the pallet truck or forklift after
conrming that battery packs are securely bound.
● When moving batteries, do not remove protective components such as
protective covers or waterproof caps from battery terminals.
● Exercise caution when moving batteries to prevent bumping and ensure
personal safety.
● Install and secure batteries horizontally from the bottom up and from left to
right to prevent falling over due to imbalance.
● When connecting batteries, ensure that the spring washer on the screw is
leveled, that the protruding part of the terminal on the cable faces outwards,
and that the cable is intact.
● Install and secure batteries horizontally from the bottom up and from left to
right to prevent falling over due to imbalance.
● Ensure that the power circuit breaker is OFF before installing batteries.
● Keep the battery loop disconnected during installation and maintenance.
● Do not use a damaged battery (such as damage caused when a battery is
dropped, bumped, bulged, or dented on the enclosure), because the damage
may cause electrolyte leakage or ammable gas release. In the case of
electrolyte leakage or structural deformation, contact the installer or
professional O&M personnel immediately to remove or replace the battery. Do
not store the damaged battery near other devices or ammable materials and
keep it away from non-professionals.
● Before installing a battery pack, check that its enclosure is not deformed or
damaged.
5.1 Checking Before the Installation
Checking the Outer Packing
Before unpacking the battery, check the outer packing for damage, such as holes
and cracks, and check the battery model. If any damage is found or the battery
model is not what you requested, do not unpack the product and contact your
dealer as soon as possible.
LUNA2000-(5-30)-S0
User Manual 5 System Installation
Issue 15 (2024-01-12) Copyright © Huawei Digital Power Technologies Co., Ltd. 65