6.2.3 Connecting Internal Signal Cables
Connecting Signal Cables Between the Power Control Module and Battery
Expansion Modules
● The protective housing of the communications terminal delivered with the device can be
fastened with clips or screws based on the actual diagram.
● Connect the communications terminals of the power control module and battery
expansion modules in sequence and secure them using cable clips. Install the internal
signal cables described in this section using the three signal cables with a diameter of 5
mm and rubber plugs delivered with the DCDC. Do not use signal cables with a
diameter of 7 mm. Do not install a cable with a diameter of 5 mm into a Ф7 mm
rubber plug, the 7 mm hole is used to connect to an inverter or cascaded battery.
Figure 6-4 Securing With Clips
LUNA2000-(5-30)-S0
User Manual 6 Electrical Connection
Issue 15 (2024-01-12) Copyright © Huawei Digital Power Technologies Co., Ltd. 83
To Next Page
Loading...
